Hi,
We do have setup a scheduled backup job (system drive C:) in Windows Server backup on our Windows Server 2008 R2. Everything is okay for a couple of months. Then just recently we’ve found out that the backup is failing with an error 517.
We have also noticed a bunch of error and warning on the event viewer -> system while the backup job is running (event id: error 11 and24606; warning 129). When the backup job fails, all the errors were gone as well.
Application error
The description for Event ID 517 from source Microsoft-Windows-Backup cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on the local computer.
If the event originated on another computer, the display information had to be saved with the event.
The following information was included with the event:
EV_RenderedValue_0.00
2147943517
%%2147943517
The resource loader failed to find MUI file
System error
Warning ID 129, Source HpCISSs2
Reset to device, \Device\RaidPort0, was issued.
Error ID 11, Source disk
The driver detected a controller error on \Device\Harddisk0\DR0.
Error ID 24606, Source Cissesrv
Logical drive 1 configured on array controller E200i [Embedded] returned a fatal error during a read/write request from/to the volume.
Logical block address 2700704, block count 128 and command 32 were taken from the failed logical I/O request.
Array controller E200i [Embedded] is also reporting that the last physical drive to report a fatal error condition (associated with this logical request), is located on bus 0 and ID 1.
"
Everything seems to be working fine aside from the backup keeps on failing with the above errors. Note that all other backup job for other drive were successful.
Thanks,
J