Hey Guys
I've been trying to configure DirectAccess but have run into a few issues with DNS. It appears that my test client can connect but I can only ping the IPv6 representations of IPv4 addresses on the network. I literally can't do anything else. As far as I can see it looks as if NAT64 is kind of doing what it's supposed to in translating my IPv6 pings to IPv4, I'm not convinced DNS64 is though? unless it's an underlying config setup on the DA server.
Current setup:
Internal network is IPv4 based (no IPv6 bar link local addresses on some devices).
DA server is 2012 R2 VM with 2 NIC's. NIC1 connected to DMZ (10.10.10.0) which goes out to the net through our firewall (physical interface is disconnected from internal LAN but connected directly to 2nd interface of firewall), NIC2 connected to internal LAN (10.10.9.0).
NIC1 is configured...